Operating procedures for cylindrical grinding machines.
1. When installing the grinding wheel, the action should be light. After installation, it is necessary to conduct an idle test to observe whether there is any deviation, vibration, or other phenomena. Only after there are no problems can it be used.
2. The machine tool should be kept clean and tidy. Before driving, check whether the position of its handle and travel limit block is correct.
3. When the grinding wheel approaches the workpiece, hand cranking should be used and the workpiece should be observed for any protrusions or indentations.
4. When the grinding wheel has not stopped, the coolant cannot be cleaned, or grinding, replacement, or other work cannot be carried out.
5. Flat grinding wheel, its extension should not exceed 25 millimeters, and the grinding wheel blocks should be kept parallel.
6. If there are burrs on the workpiece, they should be cleaned before processing to avoid affecting the processing effect.
7. The selection of coolant should be appropriate to avoid problems that may affect the cooling effect.
8. If the grinding wheel is not sharp anymore, diamond can be used for repair.
9. Grinding machines should choose corresponding grinding wheels and cannot be replaced by ordinary grinding wheels.