CNC cylindrical grinder is a commonly used grinding machine product with a wide range of applications. In order to use this grinder and increase its efficiency, we can perform regular maintenance on the grinder. We should pay attention to some maintenance matters during use, so as to increase the efficiency of the equipment and achieve the goal of increasing usage rate.
Firstly, the installation points should be noted. During the installation process, the operator should transport the grinder to the installation site and install it in a timely manner to avoid affecting the accuracy of the equipment. When lifting a grinder, attention should be paid to the position of the equipment to avoid tipping over. Instability of the grinder can easily cause it to tip over, which is also an unsafe measure for operators. After receiving the goods, inspection and acceptance should be carried out. If any problems are found, the manufacturer should be contacted in a timely manner for handling. After the grinder is installed, it may sometimes need to be adjusted horizontally. If the equipment installation is not smooth enough, it is mainly adjusted through screws. For the installation of new grinding wheels on CNC grinders, careful inspection should be carried out before installation to check for cracks. If there are obvious cracks in the grinding wheel, it means that the product cannot be used and needs to be replaced in a timely manner.
The following is about the maintenance knowledge of CNC grinding machines, which can be divided into pre - and post maintenance stages. The early maintenance focuses on local maintenance and repair, and operators need to conduct regular inspections and care. Clean the cooling pump, water tank, oil filter, disk, and other equipment in the early stage. Check if the screws are tightened, clean all parts of the grinder, and add lubricating oil according to regulations. Check whether the joints of each pipeline are correct in the later stage, and perform overall lubrication and fault detection on the entire equipment.
Maintenance personnel should conduct timely equipment inspections to identify and solve problems in a timely manner, reducing the probability of damage to the grinding machine. After each homework is completed, all components and sliding parts should be cleaned first and then lubricated. If the equipment is lubricated directly without cleaning, it will cause the lubricating oil to deteriorate prematurely.