Before starting the CNC cylindrical grinder, the following parts should be inspected:
(1) The oil basin in the oil tank should reach the specified oil level height;
(2) Adjust the tightness of the belt appropriately;
(3) The protective cover and grinding wheel should be securely mounted, positioned correctly, and the dust-proof felt pad should be tightly adhered;
(4) Check if the electrical system is in good condition, without short circuits, and the surrounding environment should be clean;
(5) Inject lubricating oil sequentially into the lubrication points specified in the manual of the CNC cylindrical grinder;
(6) Connect the main power supply, start the oil pump and other motors in sequence, pay attention to the operating status, and turn off the power if any abnormalities are found. Only after inspection and handling can the vehicle be started;
(7) Start the device and idle for 3 minutes, check if all parts are functioning properly, if the sound is normal, and if the coolant is unobstructed;
(8) Before installing the grinding wheel, it should be avoided from getting damp. The grinding wheel should undergo a static balance test and cracks are strictly prohibited;
(9) When installing the card grinding wheel, a paper pad of 0.5-1.0mm should be placed between the grinding wheel and the pressure plate, and evenly fastened with a wrench. It is not allowed to use an extended pipe for fastening to prevent the grinding wheel from expanding and cracking;
(10) After the four grinding wheels are installed, they should be run without load for 5 minutes. The operator of the CNC cylindrical grinder should avoid the front and confirm that the grinding wheels are running normally before use.